The main advantages of edge banding machine are firm bonding, fast, light, high efficiency, in order to achieve this effect, in addition to the purchase of a good edge banding machine, but also pay attention to the edge sealing, hot melt adhesive, substrate, working environment and operation methods and other elements. The selection of edge sealing tape should pay attention to the width, thickness, material, toughness, surface treatment degree and other factors.Hot melt glue should pay attention to the difference between high, medium and low temperature glue, match with the type of sealing tape, but also scientifically set heating control temperature and sol flow and solidification delay. The selection of the base material also has the quality, temperature, the parallelness and perpendicularity of the section. The indoor temperature and dust concentration of the working environment should also be considered. In the operation, the base material, the sideband and the speed, pressure, balance and consistency of the rubber shaft will affect the edge sealing effect.

Maintenance method of edge banding machine in use, there will be some problems and failures, common failures are:

1. Electrical failure. Including the main engine stop, heating fast, program disorder, not timely elimination, will burn out the motor and heating tube, or even damage the whole mechanical system. During maintenance, check the electrical control box, motor, heating tube, delay device, etc. This kind of repair is usually done by a professional or by the manufacturer.

2. Gas path failure. Including valve failure, air leakage, low pressure, cutting knife, feeding does not work, the main inspection of various pneumatic components in good condition, replacement parts can be carried out under the guidance of technical personnel of the manufacturer.

3. Mechanical failure. There are mainly transmission failure, uneven coating, feeding failure and cutting tool failure, the main check the mechanical parts of the good condition and firm parts, transmission parts are offset.

4. Bonding failure. Such as stick, deviation, entrain, etc., this is a comprehensive fault, and the rubber shaft, sealing strip, sol, substrate and operation. This failure may occur alternately, may also occur singularly, the specific maintenance depends on the situation.