With cost-effective numerical control cutting machine, active positioning, punching, slotting, optimization and other functions, is the entry level equipment of modern plate furniture enterprises. How to progress through the use of the machine through small things, is the beginning of the attention must be paid to.

Through the survey, it was found that 80% of customers in the use of equipment side of the equipment is not very clean, only simple cleaning of the equipment table, other parts of the finishing work did not do, this is absolutely not.

First, we must do the following:

1. Finish the table in time after finishing the cutting machine of the plate furniture;

2. Slag around the guide rail of the guide rail sorting machine;

3. Arrange the lead screw regularly to avoid foreign matter sticking on the lead screw. The lead screw determines the accuracy of the machine, so it must be arranged regularly;

4. It has been said many times that dust can cause severe damage to the circuit board in the cabinet, so it must be sorted out regularly.

Two, tool severe wear can be judged by the following aspects:

1. CNC carpenter cutting machine will present harsh call when it is working normally;

2. Listen to the spindle sound, the spindle will present significant abnormal sound;

3. In the process of CNC carpenter cutting machine, there will be a significant sensation, and the spindle of the machine tool will show a significant sensation;

4. After finishing the cutting of CNC carpenter cutter, the bottom blade will be good and bad.

CNC carpenter cutting machine tool wear stage:

Tool wear is generally divided into three stages: initial wear, normal wear, rapid wear.

Early wear stage: the main wear cause of the tool is CNC carpenter cutting machine to open the material because there is no preheating of the tool and led to the temperature of the tool is too low, and did not reach the normal cutting temperature, at the moment, the wear of the tool is the first abrasive wear, such wear has a great impact on the tool, it is very simple to form the tool collapse. This stage is a very risky stage, handling is not good, may directly lead to tool collapse tool failure.

When using CNC cutting equipment, it is very simple to break the tool at the initial wear stage. In order to avoid the phenomenon of breaking the tool, we must run in the tool. Make the cutting temperature of the tool gradually rise to a reasonable temperature, through the test proved that the tool in the running-in, the life of the tool will be added about 2 times.

The way to run in is to adhere to the reasonable use of the spindle speed condition, the feed speed will be reduced by half, the processing time is about 5~10 minutes. Take a small value when processing soft materials and a large value when processing hard metals.

When the tool through the initial wear period, the cutting temperature of the tool reaches a certain value, which is the primary wear is dispersed wear, its effect is primarily to lead to partial shedding. So, the wear is smaller and slower.

When wear to a certain extent, the tool will fail and enter a period of rapid wear. At this point, the above situation will occur, and the tool should be replaced.