If the daily use of the edge banding machine is frequent and the maintenance is not in place, over time will lead to the advance aging of the edge banding machine equipment, thus shortening the service life, so the daily care and regular maintenance of the edge banding machine is essential.

Maintenance and maintenance of the edge banding machine mainly has the following basic operations:

1. Fuel the running machine regularly.

2. Regularly check whether the screws are loose, once found immediately tighten, should be replaced if necessary.

3. Clean up the excess glue and wood chips on the edge banding machine in time to keep the operating surface of the machine clean.

4. Clear the waste around the banding machine in time to keep the operation area clean.

Repair the case of automatic edge banding machine

As the operator of the edge banding machine, all understand that the automatic edge banding machine is easy to break the head knock plate, once this happens, the repair method is as follows:

1. After the head down speed or too fast or downward pressure is too large, will make the ruler hit the plate knock plate.

Solution: Adjust the inlet/exhaust pressure regulating valve of the flush cylinder to reduce the downward speed and force.

2. The upward pressure of the front head is too large, and the front of the plate is hit by the ruler when it travels.

Solution: Adjust the pressure of the upstream pressure regulating valve in front of the banding machine to make the force soft.

3. The front head down signal travel switch position dislocation will also occur plate line to the predetermined position and can not touch the travel switch or directly touch off the switch, resulting in no signal sent and knock the board.

Solution: Adjust the position of the travel switch, and replace it directly if thereis serious damage.

4. Edge banding machine head by ruler guide wheel missing cause knock plate.

Solution: Replace the guide wheel.

5. The edge banding machine has burrs on the contact surface of the ruler.

Solution: Wear off with gauze.

In the use of the edge banding machine, if it is found that the processing of the edge banding machine affects the quality of the product, it is difficult to achieve appropriate alignment, it is necessary to check the problems of the edge banding machine itself.

The maintenance of edge banding machine or detection of the quality of the edge banding machine can be started from the following aspects:

1. Check the pneumatic device to see if it meets the needs and then adjust or replace it.

2. Strong head, pressure should be adjusted accordingly.

3. Choose the right PVC plastic thermal sealing machine head, to ensure that it can make the PVC plastic thermal sealing machine pressure uniform, stable state.

4. The pressure of the organ should be adjusted arbitrarily according to the need to meet the needs of different welding depth, the head is flexible and convenient and double spring, the edge sealing machine step light, up to the pressure standard.

5. The frequency of the banding machine should be standard and stable. The frequency of oscillation adopts the international industrial standard 13.68MHz, 27.12MHz, 40.68MHz frequency band.