First, specific requirements of operation:

1. First check the computer cutting machine all external baffle is not all good equipment.

2. Check whether there are other sundries on the operation table.

3. Connect the air pipe, see if there are more than 4 air pressure (less than 4 above the pressure beam can not be lifted).

4. The main saw blade and auxiliary saw blade are installed accurately (the main saw blade is turning and the auxiliary saw blade is turning).

5. Pressure beam is not there other debris (special attention to the saw blade, easy to damage the saw blade).

6. Open the main power supply on the control box and start the vacuum cleaner together.

7. Open the saw blade start button to see if the saw blade is working normally.

8. According to the computer cutting machine on the scale, adjust the cutting standard.

9. The board, close to the adjustment of the immediateness, press the saw material start button, you can cut the board. Each cut a standard board, first of all to cut a confession of the standard can continue to operate, otherwise adjust the standard in time.

Second, automatic computer cutting board saw quality requirements:

1. The front section can not have scratch, degumming, folding seam, severe color difference, the reverse side of the wood sheet, can not degumming, repair, severe scratch.

2. The cut board standard standard according to the material request, the first must admit qualified before mass production.

3. The cut board is necessary to square (special circumstances outside) section can not be black.

Third, automatic computer cutting board saw note:

1. Before pressing the saw material start button, to check the pressure beam can not have other debris, can not put your hand below.

2. If there is a foreign body under the pressure beam or the hand is accidentally pressed to, immediately press the urgent discontinuity or shake the sensor on the pressure beam.

3. Understand the required production material standards and wood grain direction under the working pressure satisfaction.

4. The performance of the cutting plate shall not be half way the decision to block the saw blade, it is necessary to lock the saw blade, saw blade mouth must be sharp, hand stop under the machine beam.

5. A cutting thickness can not exceed the scale set by the computer cutting machine.