‍Before the automatic edge banding machine device, it is best to check whether the ground is solid and flat. It is best to install the machine on the concrete ground surface to ensure the stability of the machine after setting. Together, the illumination of the device address is not less than 500LUX, and there is enough space for the device, operation, maintenance and maintenance.

The machine installation process is as follows:

1. Remove the packaging of fixed mechanical parts.

2. Place the machine on the ground and adjust the level.

3. The roll type edge sealing material is fixed on the machine with the storage turntable.

4. Connect the external power line, 220V 50HZ three-phase four-wire power supply, the total power line diameter should be more than 4 square centimeters.

5. Connect the air source.

6. Connect the suction pipe to the dust removal equipment.

7. Check whether the voltage is normal, to ensure that the compressed air is enough and boring.

Automatic edge banding machine can be for uneven plate may be due to cutting plate saw, cutting saw processing caused by corrugation, burr may not be straight again embellish, make the plate sealing boundary surface flat, so that the edge strip and plate fit tightly, so as to achieve a better edge effect.