Generally, when we buy the edge banding machine, as long as the machine is used normally in the future after debugging. But if there is a small problem in the use of the central edge banding machine, it can be used normally after a brief repair. In this case, we need to start debugging ourselves, but the general edge banding machine manufacturers will provide technical support, the following brief to tell us about the next edge machine debugging method and base process.

The debugging of edge banding machine mainly includes the following parts:

1. The edge banding machine feeding press wheel debugging, press wheel concave and convex according to the workpiece width, length, thickness and pressure wheel wear degree, through the pressure wheel lifting adjustment rod and code table to schedule, generally with the pressure wheel under the surface is lower than the workpiece on the surface of 3mm is appropriate (can be seen through the digital table). The pressure is too loose, the workpiece in the banding machine brief displacement, affect the quality of the banding; The pressure is too tight, the press wheel is briefly damaged, the pressure beam and column deformation is large, long-term use will form the deformation of the pressure beam and column, affecting the accuracy of the equipment; Together, it will also make the motor load of the reduction box larger, constituting trip shutdown, serious damage to the equipment.

2. Commissioning of feeding plate assembly, feeding orientation can be arranged by rolling star handle scheduling screw to drive feeding plate assembly movement. Clockwise rotation, feed by the plate to the column direction, on the contrary, to move out (there is a premilling function to move, the old model does not have this function). When the plate is not parallel with the conveyor belt, it can be arranged up and down and left and right through the scheduling screw under the component.

3. The rubber pot in and out and the size of the elastic adjustment, the glue in the rubber pot is necessary to keep in the pot mouth 1cm below, but not lower than the two reinforcement in the pot. The amount of glue should be based on the size of the workpiece, width, and thickness through the scheduling handle to schedule the amount of glue required. The access of the glue pot can be arranged by the scheduling screw behind the glue pot. The first thing is to loosen the locking nut, and then rotate the scheduling screw clockwise with the flat changing knife. The glue pot is evacuated. The size of the elastic force of the glue pot can be arranged by the nut of the lock spring behind the glue pot, rotating clockwise, the elastic force increases, and conversely, the elastic force decreases. The glue pot is too close to the front, and it is easy to damage the workpiece and equipment by the workpiece bumping into the pot. The front end has no glue or glue, but the bond is not good.

4. Commissioning of the side press wheel of the edge banding machine. The entry and exit of the side press wheel can be scheduled through the star handle behind the side press wheel. Counterclockwise rotation - side pressure wheel trek, generally in sealing workpiece side pressure wheel withdrawal about 1-3mm is appropriate, after debugging is necessary to lock firmly. The pressure of the side pressure wheel is regulated by the pressure dispatching valve, and the pressure is generally 1.5-5bar. The pressure is too large, easy to shift the workpiece from the top of the conveyor belt, the front end of the workpiece is easy to fall off the Angle phenomenon, the pressure is too small, the sealing edge bond is not good, constitute rework. Pressure scheduling should also be based on the thickness of the workpiece, length, width and sealing tape thickness, width to schedule, generally to seal the workpiece can reach the quality requirements. The press wheel is too front, the workpiece front end is also easy to fall off the Angle, together with the front saw cutting is not good, to rough, finishing and scraper, some places to repair the edge. The press wheel is too far back, the sealing edge is not bonded well, the side tape is very simple to tear off, and there is no side tape on the workpiece.

The above 4 items are the brief debugging of the edge banding machine before the start of work. Hua Weiying woodworking tips must be debugging according to the first time, so as to ensure the normal operation of the edge banding machine.