Automatic banding machine before operation preparation

1. Clean up the automatic edge banding machine and working place, and check whether the suction system is normal;

2. Check whether the glue in the glue pot is clean enough. If it is lacking, it should be properly added according to the amount;

3. Adjust the position of the balance pole according to the length and width of the workpiece;

4. Adjust the distance between the upper roller and the lower crawler according to the thickness of the workpiece, so as to ensure that the workpiece can be pressed steadily and will not hurt the workpiece surface because of too tight;

5. Adjust the size of the rubber door, so that the sealing material can be coated evenly and plentifully;

6. After the test machine, to see whether the automatic edge banding machine operation is normal;

7. Prepare the data and auxiliary materials (plate, paper, etc).

Automatic banding machine operation process

1. Heat the rubber wheel to 180℃. When the indicator light is on, turn on other switches. When edging, the temperature of the glue pot should be kept at 180℃±20℃, and the glue shaft should be kept at 200℃±20℃;

2. Load the edge sealing material, put the workpiece on the conveyor belt together, and close to the 90° guide rail baffle, and then parallel evenly advance;

3. Each processing of a workpiece, must be the first self-check;

4. Many factors affecting the quality of automatic edge banding machine, such as edge banding operation is interrupted, disturbs the time determination affects the reliability of the application of working hours, etc.

There are several ways to improve the operation rate, efficiency and quality

1. If part of the edge sealing strip fails to bond with the edge of the plate, it can be repaired with glue;

2. If necessary, tear off the edge strip, saw off or mill off the top edge;

3. When rust spots are found on the board, wipe the anti-rust oil on the machine in time;

4. Often protect the edge banding machine equipment, especially the gluing equipment of the edge banding machine;

5. The cooperation between the process flow and process (such as the first drilling plate or door edge sealing group), to clear and clear cooperation is not good will also have adverse effects.